1. Introduction

The tunnel plate dying oven is used for drying of the negative or positive plates after plate formation and plate washing process. As per requirement, the consuming resources could be gas burning or electrical heating.

The transmission type of plates could be tank chain and string roller chain, the new string roller chain transmission is suggested.

Plate collector types are vertically collecting (suitable for plate thicker than 1.2mm) and horizontal collecting (suitable for plates thinner than 1.2mm).  

2. Main Technical Parameters

2.1 Main transmission  

Main drive: power 2.2KW; cycloid reducer adopts frequency control;

Chain speed: 0.5~1.4m/min

2.2 Hot air circulation blower (3pcs)

Power 7.5KW × 3; air volume Q = 1.3m3/h; whole pressure: 1000Pa.

2.3 Waste exhaust blower: (3pcs)

Power: 1.1Kw×3

Wind amount: 3710M3/h

Full wind pressure: 333Pa

2.4 Drying oven temperature: range: 80～150℃ (Temperature in each section can be individually set)

2.5 Dimension

Outer dimensions: 22500 (L)* 1520(W)* 2385(H), Length includes: front frame: 2000mm, drying box: 18000mm, rear frame: 2500mm

2.6 Total weight: 5.7 Tons

2.7 Electricity power: 180Kw (3 groups, first section is 84Kw, second section is 60Kw, third section is 36Kw)

2.8 Air conduct

We only provide air suction blower, the user has to prepare the pipeline; please do install the outlet of air to the outdoor. 

3. Other Items

3.1 Installation.

The electric cabinet is installed at the middle part of the drying box, 1m away from the drying box, and the wires between electric cabinet and the connection box is provided. If the user needs to install the electric cabinet to other place, the user has to inform the seller to avoid misunderstanding.